cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
247
Views
0
Helpful
0
Replies

WLAN with Air Router Bridges

jacovr
Level 1
Level 1

I have the following setup.

WLAN consisting of Cisco 3602 Access Points, a WLC, running on a Cisco LAN.

I have Ubiquity Air Routers running in AP mode that acts as Bridges, to which a PLC & Workstation is connected.

With no data running over the network (Testing Phase):

  • If I ping a IP Address of 1 device - I get 0 packet loss
  • As soon as I start to Ping a 2nd IP Address, I drop to 30 - 40 % Packet loss.
  • It is irrelevant which IP I ping, it gives me 0% loss, but as soon as I start another Ping I drop to 405

What could cause this ?

0 Replies 0
Review Cisco Networking for a $25 gift card