WLC 2504 and Linksys Managed Switch

[ryan.fauzi]

Hi, I had a problem connecting cisco WLC 2504, mikrotik, and Linksys Managed Switch.

1. vlan untagged on WLC management interface.

2. DHCP Server on mikrotik. I also set this up for WLC DHCP Server and default gateway.

3. I plugged in the WLC and AIR AP3502i on Linksys Managed Switch, I set trunk port for WLC and Access port for AP.

4. From Linksys Switch there's interface to mikrotik (configured with trunk)

5. On mikrotik to Linksys Switch is bridge_Vlan interface (many vlan here)

Conditions : 

1. AP Joined, but I can't get IP address when connecting to SSID

2. All device can ping each other

3. I also have set capwap primary controller for AP

4. I don't know if there's option 43 config on linksys switch

From the case above, anyone can give me suggestions?

[Masato Ueoka]

HI
What is interface for your WLAN is it management interface or Dynamic interface?
Do you config Primary DHCP Server to milkrotik and DHCP Proxy Mode is on ?

[ryan.fauzi]

---

@Masato Ueoka wrote:
HI
What is interface for your WLAN is it management interface or Dynamic interface?
Do you config Primary DHCP Server to milkrotik and DHCP Proxy Mode is on ?

---

I used management interface for wlan

yes i config dhcp primary to mikrotik and dhcp proxy is global

is it problem?

[Masato Ueoka]

That's fine.

you have 2 option

1. disable DHCP Proxy to passthrough client dhcp packet to mikrotik.
2. WLC debug dhcp packet to see exchange of DHCP packets to isolate the problem.