07-18-2012 01:35 AM - edited 07-03-2021 10:25 PM
Hi,
Can someone please tell me why I dont have QoS roles under the QoS tab?
Here is a screen dump:
Here is the version I'm running to:
07-18-2012 02:21 AM
Well, that is strange.
I would think that roles are not supported on 2504 WLC but no document says this.
Can you please try configuring roles from CLI? and see what message you get?
HTH
Amjad
07-18-2012 02:27 AM
Hi Amjad,
I've also tried it from the cli but still nothing there either.
Do you think it would be worth upgrading the software on it?
Thanks,
Ross.
07-18-2012 02:47 AM
Hi Ross,
To be honest I don't know. I don't have 2500 WLC to double check for you.
I don't know if this is by design or you have a kind of a problem. I fear that this is per design and if you upgrad you'll find same issue.
I think anyone that has a 2500 WLC can confirm for us if he has the QoS roles or not. I tried to find a document but could not find anything say a word about the roles on 2500 WLCs specifically.
What do you get on CLI? the commands are not available?
Regards,
Amjad
07-18-2012 08:51 AM
http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_2.html
These software features are not supported on Cisco 2500 Series Controllers:
•Support for wired guest access.
•Cisco 2500 Series Controller cannot be configured as an auto anchor controller. However, you can configure it as a foreign controller.
•Supports only multicast-multicast mode.
•Bandwidth Contract feature is unsupported.
•Access points in direct connect mode is unsupported
•Service port support
•Apple Talk Bridging
•LAG
•Wired Guest
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: