Re: WLC 2504 SSID issue. - Page 2

GaneshPr1@microland.com · ‎06-08-2018

Hi All,

I have configured two WLC 2504 (Primary/ Secondary - Standalone) with two SSID.

one SSID - works with PSK key.

Primary WLC is working good.

Secondary one SSID is working good and another SSID is not getting IP to connect (Works with PSK).

Scanner is to be connecting here.

1. Compared both WLC config and remains same.

Please advise.

Thanks

Ganesh

Sandeep Choudhary · ‎06-13-2018

Ganesh,

Check if Fast-ssid is enabled or not!!! if not then enable it.

also tell me which SW version you are running on controller ?

Regards

Dont forget to rate helpful posts

GaneshPr1@microland.com · ‎06-13-2018

Yes Fast SSID enabled.

IOS version -- 8.0.140.0

Sandeep Choudhary · ‎06-13-2018

can you upgrade wlc software to 8.0.152.0 and give a try.

Regards

Dont forget to rate helpful posts

GaneshPr1@microland.com · ‎06-14-2018

Code upgraded but still same issue.

GaneshPr1@microland.com · ‎06-18-2018

Hi all,

Please let me know any other suggestion / help here ?

GaneshPr1@microland.com · ‎06-26-2018

Hi All,

Issue has been fixed now.thanks all your support.

issue identified - 802.x authentication error.

Thanks

ganesh

alois.heilmaier · ‎06-26-2018

so you mean 802.1x ? > so instead PSK .1x was configured ?

or you mean phy issues e.g. 802.11abgn ? > maybe wlan signal problems