cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1319
Views
10
Helpful
21
Replies
Highlighted

WLC 2504 SSID issue.

Hi All,

 I have configured two WLC 2504 (Primary/ Secondary - Standalone) with two SSID. 

one SSID - works with PSK key. 

Primary WLC is working good. 

Secondary one SSID is working good and another SSID is not getting IP to connect (Works with PSK).

Scanner is to be connecting here.

1. Compared both WLC config and remains same.

Please advise.

 

Thanks

Ganesh 

 

21 REPLIES 21
Highlighted

Ganesh,

Check if Fast-ssid is enabled or not!!! if not then enable it.

 

also tell me which SW version you are running on controller ?

Also check the bug: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvd18773/?rfs=iqvred

 

Regards

Dont forget to rate helpful posts

 

Highlighted

Yes Fast SSID enabled.

 

IOS version -- 8.0.140.0

 

 

Highlighted

can you upgrade wlc software to 8.0.152.0 and give a try.

 

Regards

Dont forget to rate helpful posts

Highlighted

Code upgraded but still same issue.

Highlighted

Hi all,

 

Please let me know any other suggestion / help here ?

Highlighted

Hi All,

 

Issue has been fixed now.thanks all your support.

issue identified - 802.x authentication error.

 

Thanks

ganesh

Highlighted

so you mean 802.1x ? > so instead PSK .1x was configured ?

or you mean phy issues e.g. 802.11abgn ? > maybe wlan signal problems