cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
2588
Views
10
Helpful
8
Replies

WLC 2504 stuck in SYS Amber blinking - ALM constant amber light -PWR Constant Green - no console

zayarnainghto0
Level 1
Level 1

Hi,

I cant access my wlc with console 

LED status= SYS-Amber blinking,ALM constant  amber PWR constant green.

Can I reset using reset port in front panel?

Please.

8 Replies 8

Leo Laohoo
Hall of Fame
Hall of Fame
If there is no console then the unit could be dead.

So what can I do for this?RMA is the only option ?

Yes. RMA.

Thanks Bro

Hi,
you can reset the device using console. as per your details, device is in faulty mode. if you cannot get the console to the device, its better initiate a TAC with cisco and get a RMA.

regards,
Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Thanks for your information bro.

please mark as answer and rate helpfull if so :)
Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

jturner2720
Level 1
Level 1

I assume you've tried the obvious first and powercycled the unit?

I've had numerous occasions where 5508s have got stuck with blinking alarm and no response on the console, but turning off and on again gets them back working again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: