cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
571
Views
15
Helpful
8
Replies
syed baseeruddin
Beginner

WLC 2504 there is no RP Port

 
2 ACCEPTED SOLUTIONS

Accepted Solutions

That is correct, the 2504 do not support SSO. Just N+1 HA

BR

View solution in original post

Sandeep Choudhary
VIP Mentor

As other mentioned that 2504 WLC dont support AP/Clinet SSO, it just support N+1.

Here is the my post for N+1 implementation on 2504:

https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/

Regards

Dont forget to rate helpful posts

View solution in original post

8 REPLIES 8
William Kuczmera
Beginner

To my knowledge the 2504 does not support AP SSO. 

http://www.cisco.com/c/en/us/support/docs/wireless/2500-series-wireless-controllers/113034-2500-deploy-guide-00.html

That is correct, the 2504 do not support SSO. Just N+1 HA

BR

View solution in original post

Thanks ALL,

For connections of Both Controller can we connect to port 2 of wlc 1 and port 2 of wlc 2 through cross cable or straight Cable.

please correct me if am wrong

And Here in option 43 we have two ips of two controllers

In AP sso each one ip for both controllers in option 43

Hi,

For connections of Both Controller can we connect to port 2 of wlc 1 and port 2 of wlc 2 through cross cable or straight Cable.

No, You dont need to connect any port between wlcs.  Just setup both controller in N+1 as per my last post.

In AP sso each one ip for both controllers in option 43

2504 dont support AP SSO.

Set both WLC IP in hex format in option 43

Regards

Dont forget to rate helpful posts

Thanks Sandeep

one question

I make Mgmt Vlan as untagged in wlc  and in core switch i make as access mode port(vlan20) for wlc 1 and wlc 2

in core int ten1/0/12

             switch mode access

            switch access vlan 20

for ssid vlan in microscoft server 2003 i am not able to get ip add for client

when change  ssid vlan for mgmt for testing it is taking ip for clients

please advice

Hi,

Configure the switch port as trunk where WLCs are connected:

Example: WLC mgmt interface : 20 and client vlan is 60

so config looks like this:

interface GigabitEthernet1/0/1
description Trunk Port to Cisco WLC
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 20,60
switchport mode trunk
no shutdown

*** Normally i tag the wlc mgmt vlan

Regards

Dont forget to rate helpful posts

Thanks Sandeep

Sandeep Choudhary
VIP Mentor

As other mentioned that 2504 WLC dont support AP/Clinet SSO, it just support N+1.

Here is the my post for N+1 implementation on 2504:

https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/

Regards

Dont forget to rate helpful posts

View solution in original post

Content for Community-Ad