cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
720
Views
0
Helpful
6
Replies
Highlighted
Beginner

WLC 4400 and 5500 Fail-over

Can we do the same thing with WCL 4400 and 5500 series for failover? We have 1 existing 4400 WLC and we wanted to purchase another 1 for fail-over as well as backup. But right now, 4400 is EOL already. The only option is to have the 5500 WLC.

So if you do have previous set-up like this, so I would need your inputs.. Otherwise, same as usual, will gonna test to work this out.

6 REPLIES 6
Highlighted
Hall of Fame Master

You can have both in a primary and backup, but make sure they are on the same code version. I'm assuming that you also have the configuration correct for the two wlc to communicate.

I would put them both on the 7.0.220.0.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Highlighted

Hi Scott, thank you very much for your prompt response. I will keep you posted if I do encounter some issues.

Highlighted

Sounds good.

-Scott
*** Please rate helpful posts ***
Highlighted

Hi Scott,

Just would like to ask some verification from your end. Is NCS a replacement for WCS? or it's just another piece of software that is built from WCS platform?

Highlighted
Hall of Fame Community Legend

Just would like to ask some verification from your end. Is NCS a replacement for WCS?

NCS replaces the WCS.

NCS comes in two "flavours":  VMware and appliance

Highlighted

Hi Leo,

Ah.ic..Thanks much for your prompt response...Keep it up.

Content for Community-Ad