cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
869
Views
0
Helpful
2
Replies
sebastien1111
Beginner

WLC 5508 - Radio interface reset

We install two controllers WLC 5508 with terminals 1600 and 1242, since the commissioning we have the AP radio cuts every 4 hours as an error message:
Log of the controller:

08 Thu May 28, 2015 2:36:23 p.m. AP's interface: 1 (802.11a) Operation State Up: Base Radio MAC: 00: 3a: 99: a9: 99: b0 = Cause Radio reset interface. Status: NA
409 Thu May 28, 2015 2:36:22 p.m. AP's interface: 1 (802.11a) Operation State Up: Base Radio MAC: 00: 3a: 99: a9: a5: 20 Cause = Radio reset interface. Status: NA
410 Thu May 28, 2015 2:36:22 p.m. AP's interface: 1 (802.11a) State Operation Down: Base Radio MAC: 00: 3a: 99: a9: 99: b0 = Cause Radio reset interface. Status: NA
411 Thu May 28, 2015 2:36:22 p.m. AP's Interface: 0 (802.11b) Operation State Up: Base Radio MAC: 00: 3a: 99: a9: 99: b0 = Cause Radio reset interface. Status: NA
412 Thu May 28, 2015 2:36:21 p.m. AP's Interface: 0 (802.11b) State Operation Down: Base Radio MAC: 00: 3a: 99: a9: 99: b0 = Cause Radio reset interface. Status: NA
413 Thu May 28, 2015 2:36:21 p.m. AP's interface: 1 (802.11a) Operation State Up: Base Radio MAC: 00: 3a: 99: a9: 99: b0 = Cause Radio reset interface. Status: NA



The controller is 8.0.115 and terminals

2 REPLIES 2
Saurav Lodh
Rising star

Issue Show msglog to see detail events Show traplog. Since there are two WLC, it may happen they are disconnecting with present WLC and getting connected to the another one. Even switch line outage could be a reason

Yahya Jaber
Participant

Hi,

 

check the DCA interval.

Content for Community-Ad