10-06-2021 10:15 AM
WLC 9800-40 How we can enable 2.4ghz and 5ghz after shutdown.
WLC(config)#no ap dot11 5ghz shutdown
% switch-1:dbm:wireless:802.11a network not supported for this Country Code
10-06-2021 12:10 PM
what is the country code you have configured? Below is the guide to configure the country codes.
10-06-2021 12:17 PM
US but still getting error
WLC(config)#no ap dot11 5ghz shutdown
% switch-1:dbm:wireless:802.11a network not supported for this Country Code
10-06-2021 12:32 PM
Is there any incompatibility between the AP models and the country code configured?
Rasika
10-06-2021 12:35 PM
10-06-2021 12:48 PM
I have tested a couple of my test VM, no issue of enabling/disabling using that CLI.
which IOS-XE version are you running on this WLC? if not 17.3.4, I would upgrade to it.
Depend on the AP model you are planning to use on this WLC you can decide. If you have Wave 1 AP models (x700 series) then 17.3.x is the last code it supports them.
If all are 91xx series AP, I would consider 17.6.x
HTH
Rasika
10-06-2021 01:03 PM
Also can you post the output for the below
show running-config all | include ap dot11
02-07-2023 01:55 AM
Hello,
I think the command you're looking for is:
ap name AP_NAME no dot11 24ghz shutdown
Best regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: