01-23-2021 07:30 AM - edited 07-05-2021 01:04 PM
Hi guys,
Fresh installation with 2 unit WLC9800 and 4 type of AP below:-
1) AIR-AP3802E-K-K9
2) AIR-AP3802I-K-K9
3) AIR-AP1562E-L-K9
4) IW-6300H-AC-L-K9
WLC controller ver 17.4.01
All type of AP success join to WLC accept IW-6300H-AC-L-K9 model. any special configuration for this AP?
Your advice are really appreciate.
Thanks
Solved! Go to Solution.
01-23-2021 09:02 PM
01-23-2021 09:06 AM
- Check if the particular AP is compatible with the controller-platform :
M.
01-23-2021 09:43 AM
Hi Marce
Thanks for the reply.
Seen mentioned AP in list -> Cisco Catalyst Industrial Wireless 6300 Heavy Duty Series Access Point
01-23-2021 10:26 AM
- 'Seen' or being mentioned is not enough , you need to lookup for instance, first AireOS or XE controller-software support-release (e.g.)
M.
01-23-2021 09:02 PM
Problem solve
on CLI just change the mode AP. "capwap ap mode local"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: