11-06-2020 12:30 AM - edited 07-05-2021 12:45 PM
Good Day,
How can I trunk the interface(s) directly on the WLC CLI?
Thanks
11-06-2020 01:30 AM
You just need to configure trunk on switch port not on WLC side.
Regards
Dont forget to rate helpful posts
11-06-2020 01:36 AM
Thank you - I have done so but then I lose connectivity to the WLC
11-06-2020 01:41 AM
paste the config of swicthport where WLC is connected.
Also paste the output of this command from WLC: show interface detail management
11-06-2020 01:50 AM
Hello,
Below resolved my issue: configuring the uplink on the switch with below (I did not add the config: switchport trunk native vlan x)
switchport
switchport trunk native vlan x
switchport mode trunk
Thanks again
11-06-2020 05:32 AM
Both side configuration must match else it will not work.
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: