ā12-10-2020 05:18 AM - edited ā07-05-2021 12:53 PM
Hi,
I am installing a 3504 WLC . The WLC is located at Brazil and the RADIUS servers are at Australia.
Can some one tell what should be the maximum TTL between the WLC and the RADIUS server as part of cisco's best practice?
Also is there is any guide/link to refer, please share with me,
ā12-10-2020 05:54 AM
depend if there is VPN or not from site to site.
ā12-10-2020 08:42 AM
- Presumably if the TTL falls within the spec mentioned below - you will be safe :
M.
ā12-10-2020 09:04 AM
ā12-10-2020 09:12 AM
Below is the ping response of the two RADIUS servers. I tried to ping the RADIUS servers from the switch where wlc is connected. Is this a 300ms roundtrip would cause any delay? What is recommended round trip as per best practices
switch#ping x.x.x.x
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to x.x.x.x, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 330/336/340 ms
switch#
switch#ping y.y.y.y
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to y.y.y.y, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 330/334/340 ms
ā12-10-2020 09:18 AM
are you use any DMVPN WAN ?
ā12-10-2020 09:42 AM
NO. DMVPN is not used.. It is MPLS here.
ā12-10-2020 09:57 AM
What radius server are you using?
ā12-10-2020 10:02 AM
RADIUS server is hosted on Azure cloud.
ā12-10-2020 12:26 PM - edited ā12-10-2020 12:27 PM
What radius server is it? You can host different radius servers like ISE, ClearPass, etc. You should reach out the to manufacture of the radius or hit up the forum for that radius server to get some suggestions.
ā12-10-2020 09:32 AM
ā12-10-2020 09:42 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: