01-27-2012 05:44 AM - edited 07-03-2021 09:27 PM
Hi,
We have 2500 Series WLC.
I have registered our remote office APs to head quarter.
There are 3 ssids. For voice, Data and Guest network. From remote office all networks comes to headquarter.
What I wanna do is:
I want to seperate networks. Data and voice netwroks must come to headquarter but Guest network must use local gateway to connect internet.
The ap is registered as local. Can I do this with H-REAP???
There is VPN network between offices.
Solved! Go to Solution.
01-27-2012 05:47 AM
The only way you can use a local subnet is by setting up the ap in h-reap mode. This allows you to specify the SSID and local vlan. You will need to configure the port the ap is connected to as a trunk port and native vlan of the ap management address. You will also need to enable h-reap local switching on the SSID.
Thanks,
Scott Fella
Sent from my iPhone
01-27-2012 05:47 AM
The only way you can use a local subnet is by setting up the ap in h-reap mode. This allows you to specify the SSID and local vlan. You will need to configure the port the ap is connected to as a trunk port and native vlan of the ap management address. You will also need to enable h-reap local switching on the SSID.
Thanks,
Scott Fella
Sent from my iPhone
01-27-2012 05:49 AM
Also note, that if you centrally switch your Data SSID, if a user prints, the traffic will come back to HQ and then back out to the remote site.
Thanks,
Scott Fella
Sent from my iPhone
01-27-2012 06:45 AM
Thanks Scott
I will do the H-Reap config.
01-27-2012 06:50 AM
No problem... Let us know if you run into any issues.
Thanks,
Scott Fella
Sent from my iPhone
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: