cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
690
Views
10
Helpful
1
Replies

WLC>show advanced 802.11a channel

i have a query on Local Automatic Channel assignment And Leader  automatic channel assignment, there is channel update interval 24hours and 600 seconds respectively. what is difference between two and how it will impact our environment.

 

Note: wlc2504 running IOS 8.3.150.6

 

the mention command output,

Cisco Controller) >show advanced 802.11a h channel

Local Automatic Channel Assignment
Channel Assignment Mode........................ AUTO
Channel Update Interval........................ 24 Hours
Anchor time (Hour of the day).................. 0
Update Contribution
Noise........................................ Enable
Interference................................. Enable
Load......................................... Disable
Device Aware................................. Disable
Clean Air Event-driven R RM option............... Enabled
Clean Air Event-driven R RM sensitivity.......... Medium
Clean Air Event-driven R RM Rogue Option......... Enabled
Clean Air Event-driven R RM Rogue Duty Cycle..... 80
Channel Assignment Leader...................... DEL-WLC-02 (192.168.1.38) (::)
D CA Sensitivity Level.......................... MEDIUM (15 dB)
D CA 802.11n/ac Channel Width................... 20 MHz
D CA Minimum Energy Limit....................... -95 dB m
Channel Energy Levels
Minimum...................................... -80 dB m
Average...................................... -79 dB m
Maximum...................................... -78 dB m
Channel Dwell Times
Minimum...................................... 0 days, 00 h 36 m 56 s
Average...................................... 0 days, 01 h 31 m 01 s
Maximum...................................... 0 days, 10 h 13 m 51 s
802.11a 5 GHz Auto-RF Channel List
Allowed Channel List......................... 36,40,44,48,52,56,60,64,149,
153,157,161
Unused Channel List.......................... 165,169,173
D CA Outdoor AP option.......................... Disabled

Leader Automatic Channel Assignment
Channel Assignment Mode........................ AUTO
Channel Update Interval........................ 600 seconds
Update Contribution
Noise........................................ Enable
Interference................................. Enable
Load......................................... Disable
Device Aware................................. Enable
D CA Sensitivity Level.......................... MEDIUM
Allowed Channel List......................... 36,40,44,48,52,56,60,64,149,
153,157,161

 

1 Reply 1

Do you have multiple controllers in the same mobility group? If so, 24hrs is the DCA channel interval setting in RF-Leader, the other setting is the local controller.

 

HTH

Rasika

*** Pls rate all useful responses ***

Review Cisco Networking products for a $25 gift card