cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1733
Views
0
Helpful
2
Replies
Highlighted
Beginner

WLC - How to map VLAN only from FlexConnect Group?

Hi there

 

I have a WLC and have setup a FlexConnnect group..

 

I have since setup another FlexConnect group with different SSID's 

 

I want only a certain number of AP's in FlexConnect Group 1 and another in Flex Connect Group 2.

 

This way I can separate SSID's however my WLAN's are getting inherited to all FlexConnect AP's with inheritance type 'Wlan-Specific'

 

I want to remove wlan specific inheritance and only use Group-Specific

 

Can this be done?

 

Regards

 

Mohamed

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Yes you can do that if, you are looking to create 2 WLAN and 2 AP groups to use specific WLAN.

Steps will be as below.

1. Create WLAN 1 & 2

2. Create AP group 1 & 2 allow WLAN 1 to APgrp1 & 2 to 2

3. Once your AP is associated to the WLC convert from local mode to Flex connect.

4. After it get rebooted, the AP will have one more option of configuration named Flex- connect - map VLAN apply native VLAN & VLAN ID.

5 . Apply the trunk port configuration on the switch ports the AP will be connected and also enable the flex connect local mode in the WLC WLAN advance option 

View solution in original post

2 REPLIES 2
Highlighted
Beginner

Yes you can do that if, you are looking to create 2 WLAN and 2 AP groups to use specific WLAN.

Steps will be as below.

1. Create WLAN 1 & 2

2. Create AP group 1 & 2 allow WLAN 1 to APgrp1 & 2 to 2

3. Once your AP is associated to the WLC convert from local mode to Flex connect.

4. After it get rebooted, the AP will have one more option of configuration named Flex- connect - map VLAN apply native VLAN & VLAN ID.

5 . Apply the trunk port configuration on the switch ports the AP will be connected and also enable the flex connect local mode in the WLC WLAN advance option 

View solution in original post

Highlighted

Hi Lenkasurat

 

Thank you very much for your response this indeed has resolved my problem 

 

Kind Regards

 

Mohamed 

Content for Community-Ad