05-14-2007 04:07 AM - edited 07-03-2021 02:03 PM
Hi,
I will be deploying 2 units of WLC4402, which run as active-passive (all the LAP will be registered to the primary WLC, the secondary WLC will only come up when the primary WLC fails).
Since I will be creating multiple VLAN to be associated to the WLAN(SSID) on both WLC,
1) May I know the VLAN IP address of the 2 WLC are the same or it must be different?
ANd we plan to have the LAP and WLC to be in the same subnet, does that means I will be running on Layer 2?
2) and if this is the case, I do not need DHCP option 45, right?
I'm new to the Unified wireless, and I can't seems to find the answer anywhere..or maybe I'm in the wrong URL..
Thanks in advance.
10-23-2007 07:38 AM
Thanks Ankur, Please find the command out put what you have requested.
Controller 1:
(WLC-ITC1) >show mobility summary
Symmetric Mobility Tunneling (current) .......... Disabled
Symmetric Mobility Tunneling (after reboot) ..... Disabled
Mobility Protocol Port........................... 16666
Mobility Security Mode........................... Disabled
Default Mobility Domain.......................... ITCMOBGROUP
Mobility Keepalive interval...................... 10
Mobility Keepalive count......................... 3
Mobility Group members configured................ 2
Controllers configured in the Mobility Group
MAC Address IP Address Group Name Status
00:18:ba:49:75:60 10.17.211.15 ITCMOBGROUP Up
00:18:ba:49:77:a0 10.17.209.15
Controller 2:
Symmetric Mobility Tunneling (current) .......... Disabled
Symmetric Mobility Tunneling (after reboot) ..... Disabled
Mobility Protocol Port........................... 16666
Mobility Security Mode........................... Disabled
Default Mobility Domain.......................... ITCMOBGROUP
Mobility Keepalive interval...................... 10
Mobility Keepalive count......................... 3
Mobility Group members configured................ 2
Controllers configured in the Mobility Group
MAC Address IP Address Group Name Status
00:18:ba:49:75:60 10.17.211.15
00:18:ba:49:77:a0 10.17.209.15 ITCMOBGROUP Up
Could you please confirm the configuration is correct or not?
thanks
raj
10-23-2007 07:42 AM
Hi Raj,
Your config and output makes me believe your mobility should work fine. Is your AP fallback not working?
Regards,
Ankur
10-23-2007 07:38 AM
Initial discovery of a controller is required for an AP to associate to a controller. After that, the AP learns the location of controllers within the mobility group. Maybe I was a little confusing there.
10-23-2007 08:01 AM
Thanks Dennis and Ankur... after restarting all the APs once again, it worked. i tested both the way, its working fine. Thank you for helping me.
regards
raj
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide