03-26-2020 11:34 PM - edited 07-05-2021 11:53 AM
Hi,
Trying to upgrade and predownload image to AP:s fails.
After the FTP transfer to the WLC controller the "show boot" command should display the new firmware version as the primary. But this doesn't happen.
Tried uploading the firmware multiple times and all every time the result was "successfull" but nothing happens to the primary image.
I'm trying to do an upgrade from 8.10.105.0 to 8.10.112.0
Any ideas?
03-27-2020 02:35 AM
- If possible post complete 'logging-trail' of the upgrade attempt tried. In that manner use CLI to upgrade to have the verbose output. Also configure for this case a syslog server from the controller to a syslog agent. Check the syslog-agent's logs afterwards , look for errors.
M>
03-27-2020 03:08 AM - edited 03-27-2020 03:39 AM
Opened a case with cisco.
thanks
03-27-2020 04:33 AM
- Don't bother I am better (just kidding of course). More valuable however is the idea that if you get valuable feedback from Cisco to share it here too, since after all you also posted the question in this forum (I don't think CISCO, will mind because they are very busy in these covid-times).
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide