cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
883
Views
0
Helpful
3
Replies

WLC5508 with SW6500 VSS mode

Hi all,

Unfortunatelly, I haven't enough experience on CISCO wireless controller and I'm not able to find an official answer for this question:

My customer has two SW6500 on VSS mode connected via VSL. I wish to know if anyone have already connected WLC5508 with SW6500 VSS using LAG feature ?

I wish to connect one uplink from LAG to the first switch and the second uplink to the other. The two switches are considered like one logical software.

I have already read the best practice from CISCO when we connect a 5508 to a switch regarding the port-channel but nothing regarding VSS and VSL link.

Thanks in advance.

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

It does work as long as the two chassis are in vss:)  Make sure the the etherchannel load balancing is configured for src--dst-ip

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

View solution in original post

3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame

It does work as long as the two chassis are in vss:)  Make sure the the etherchannel load balancing is configured for src--dst-ip

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Thanks in advance,

Installation done today, works perfectly.

Good news and thanks for using the rating system!

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card