06-21-2007 11:01 PM - edited 07-03-2021 02:14 PM
when i update my 1131 APs, WLSE send this message ;
Inconsistent device state found:
CISCO-DOT11-IF-MIB cd11IfStationConfigTable.cd11IfStationRole must be in the range [1..11] (was 0)"
Solved! Go to Solution.
06-22-2007 07:33 AM
Hi,
Please mark this thread as resolved so that others can benefit for it.
Thanks,
Prem
06-22-2007 04:04 AM
Hi,
Check this out,
CSCsi58022 : IOD : Inconsistent Error messages in WLSE for 1130 and 1240
IOD : Inconsistent Error messages in WLSE for 1130 and 1240
Alternate Headline: IOD : Inconsistent Error messages in WLSE for 1130 and 1240
Symptom:
====================
WLSE reports a fault as follows.
Inconsistent device state found: Device "APXXXX": ifIndex=1, MAC=XX-XX-XX-XX-XX-XX: "CISCO-DOT11-IF-MIB cd11IfStationConfigTable.cd11IfStationRole must be in the range [1..11] (was 0)"
Condition:
===========
Reproducibility : unknown
Frequency : unknown
Components:
==================
WLSE Ver2.15
Aironet Ver12.4(3g)JA
Workaround:
==========
This phenomenon doesn't impact function.
Regards,
Prem
06-22-2007 04:50 AM
OK , thanks
06-22-2007 07:33 AM
Hi,
Please mark this thread as resolved so that others can benefit for it.
Thanks,
Prem
04-19-2008 04:36 AM
Hi,
i've the same problem of this discussion, the system is composed of:
WLSE 1030 Release 2.15
AP 1240 with IOS 12.4(10b)JA3 and 12.4(10b)JA
In partcoular, all APs have the radio interface 802.11a turned off, but i always see this fault:
Inconsistent device state found: Device "AP254.xxxxx.xxx": ifIndex=2, MAC=00-1c-57-84-af-20: "CISCO-DOT11-IF-MIB cd11IfStationConfigTable.cd11IfStationRole must be in the range [1..11] (was 0)"
i would like to know if there is a way to hide this fault permanently.
Is possible that this is a bug (CSCsi58022)?what is the solution?
thanks a lot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide