WLSE & SNMP unreachable fault

[gauthrayj]

Hello,

I configured my WLSE to check if my AP (AP1231 and AP1131) are SNMP reachable once every ten minutes. I want to have an fault only when SNMP reachability is down for 3 consecutive polling cycles = if an AP is down for 20min

Actually, I get a fault as of the first time wlse polls the access point.

Anyone knows why wlse reacts like that ?

Thank you

Regards

[a-vazquez]

This clearly looks like a configuration issue. I think the polling of the APs has not been set correctly. That is the reason you are getting unexpected results. Recheck the polling configuration.

[gauthrayj]

Actually, I checked my configuration and I saw that during the upgrade from 2.12 to 2.13 the fault profiles I configured was not upgrade :

For example we don't have the same name for the SNMP reachable fault :

MO Names | Policy Names

wlse2.12 : AccessPoint | SNMPReachable

WLSE2.13 : IOSAccessPoint | SNMPReachable

It seems that I have to create a new profile...

Anyone has the same trouble when upgrading 2.12 to 2.13 ?

Thx