cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1801
Views
0
Helpful
1
Replies

ASR 9000 XR, ip igmp snooping querier

odahlqvist
Level 4
Level 4

Hi

Is there any similar solution like in Cisco 7600, where you can put in the "ip igmp snooping querier" under the SVI to get the local Multicast feature if you dont need the Multicast routing support more than for the local vlan.

So in the following interaface, that is terminationg the vlan, there need to be a igmp snooping querier to solve the mrouter port in the catalyst 6500 world like in the link below

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008059a9df.shtml

interface Bundle-Ether300.1

vrf 201

ipv4 address 192.168.5.3 255.255.255.0

encapsulation dot1q 1

Is there a solution to this in the ASR 9000, XR if you don't want/need to activate full  multicast-routing ?

1 Reply 1

Laurent Aubert
Cisco Employee
Cisco Employee

Hi,

Yes it is supported on the ASR9k but all IGMP snooping config is done at the Bridge-domain level. Please refer to the following link for the details:

http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.1/multicast/configuration/guide/mc41igsn.html

HTH

Laurent.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: