hello everyone, pwhe has been implemented in our network scenario, but we have the failure after that, the clients stop receiving the v6 network via dhcp, could anyone help in this case? follows the current configuration, detail that before the change to pw-ether the dhcpv6 ok for customers
interface PW-Ether10
mtu 1500
ipv4 address 100.100.0.1 255.255.224.0
ipv4 verify unicast source reachable-via rx
ipv6 nd prefix 2001:db8:5000::/64 no-adv
ipv6 nd other-config-flag
ipv6 nd managed-config-flag
ipv6 verify unicast source reachable-via rx
ipv6 address 2001:db8:5000::1/64
ipv6 enable
attach generic-interface-list pw_he
ipsubscriber ipv4 l2-connected
initiator dhcp
!
ipsubscriber ipv6 l2-connected
initiator dhcp
!
ipv4 access-group NAT-FILTER ingress
!
===================================================
l2vpn
load-balancing flow src-dst-ip
pw-class P1
encapsulation mpls
transport-mode vlan passthrough
load-balancing
flow-label both
!
!
!
xconnect group DHCP
p2p pw-ether10
interface PW-Ether10
neighbor ipv4 172.16.100.10 pw-id 10
pw-class P1
!
!