ASR9k has 2 system HP queue and a default queue, there is no dokument i can find that descripe how packets are mapped into this system level queues per default, from packet enter the ingress interface util the packet leave the egress interface.
If you configure the priority-level at the egress direction as output policy, will the packet matched be tagged with this same system level priority from ingress port already? The reason is that from bridge FPGA towards NP there is only 15Gbps full duplex bandwdith, if traffic are not tagged with hp from the ingress already, it will be dropped when traffic over 15 Gbps.
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...
When I run the command 'sh controllers fabric fia q-depth location 0/0/CPU0' or any 0/X/CPU0 and see the following, what exactly does it mean? RP/0/RSP0/CPU0:Router#sh controllers fabric fia q-depth location 0/0/CPU0********** FIA-0 **********Categor...
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.