we are new on ASR and IOS XR. We have an ASR 9006 with the line card in the discussion subject (A9K-MPA-4X10GE). The four leds on the card are red. Is there any command to activate? Is a Layer 1 problem?
Our release is Cisco IOS XR Software, Version 4.3.0[Default].
IOS upgrade on asr9xx mandates rommon upgrades sometimes while they can be optional at other times. You may land up in unwanted situation if proper procedure is not followed during upgrades.
This article will include complete details about rommon ...
In some situation NCS560 RP become unresponsive after reload or powercycle.
In many deployments NCS560 far edge, deployment is large and human intervention should be kept at minimum
Engineering team have been working on a strategy to have functi...
In simple terms, 'Route Churn' is defined as the 'rate of change of prefixes'. Different XR versions across 4.x to 7.x have differing behavior & support for the BGP churn handling and some enhancements made from 6.5.3 onwards (listed in appendix) mak...
Prior to Cisco IOS XR Software Release 7.1.2, XR dual RP devices did not support file mirroring from active RP to standby RP. Administrators had to manually perform the task or use EEM scripts to sync files across active RP and stand...
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...