07-13-2022 08:42 PM
I was unable to set the following command in version 7.1.x of the ASR9901.
I was able to configure it in version 7.0.x. How do I enable it?
RP/0/RSP0/CPU0:router(config)#multicast-routing
^
% Invalid input detected at '^' marker.
RP/0/RSP0/CPU0:router(config)#router pim
^
% Invalid input detected at '^' marker.
07-13-2022 10:01 PM
It looks like you are missing the multicast pie that is needed to support multicast.
You can verify this with "show install active"
07-14-2022 12:28 AM
Thank you very much.
The package was not installed in show install active.
07-14-2022 05:59 AM
Maybe missed during the upgrade :). If you install it the commands should appear again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: