I need to come up with a baseline syslog script for XR and XE platforms and integrate them both with CoPP but the documentation I search doesn't cover both topics or how to change the port. I see some commands for switches to change the port but the ASR 9000 XR docuemntation doesn't show that as an option. Is there someone out there good with documentation that can provide me with some documentation with the correct command syntax and detailed show commands to verify configuration?
1: Hardened remote XR syslog basline script and a CoPP ACL to allow that conversation to occur.
2. Hardened remote XE syslog basline script and a CoPP ACL to allow that conversation to occur.
3. Configure a different syslog port beside UDP 514.
4. Source the syslogs from a specific IP address not just the interface it went out on.
I am not sure what is meant by baseline script? If you enable a syslog server in your configuration then it will stream to the server, we don't support TCP based syslog.
RP/0/RP0/CPU0:NCS-55A1-A(config)#logging ? A.B.C.D or X:X::X IP v4/v6 address of the logging host WORD Name of the logging host archive logging to a persistent device(disk/harddisk) buffered Set buffered logging parameters console Set console logging correlator Configure properties of the event correlator events Configure event monitoring parameters facility Modify message logging facilities file Set file logging format Specify syslog message format send to the server history Set history logging hostnameprefix Hostname prefix to add on msgs to servers ipv4 Mark the dscp/precedence bit for ipv4 packets ipv6 Mark the dscp/precedence bit for ipv6 packets localfilesize Set size of the local log file monitor Set monitor logging source-interface Specify interface for source address in logging transaction s suppress Configure properties for the event suppression suppress Suppress logging behaviour tls-server Secure server over tls trap Set trap logging RP/0/RP0/CPU0:NCS-55A1-A(config)#logging 188.8.131.52 ? port Set UDP port for this remote host/vrf severity Set severity of messages for particular remote host/vrf vrf Set VRF option RP/0/RP0/CPU0:NCS-55A1-A(config)#logging 184.108.40.206 port 65000 RP/0/RP0/CPU0:NCS-55A1-A(config)#logging 220.127.116.11 severity debugging RP/0/RP0/CPU0:NCS-55A1-A(config)#logging source-interface loopback 1 RP/0/RP0/CPU0:NCS-55A1-A(config)#show Thu Jul 2 16:43:30.909 UTC Building configuration... !! IOS XR Configuration 7.1.1 logging 18.104.22.168 vrf default severity debugging logging source-interface Loopback1 end