XR OS and Platforms

Asking all our customers.   Looking for some other examples where we had an issues on the a9k where we might have some gap in system resiliency.  Looking for issues where we might have seen a HW or SW issue and the router didn't handle it in a way yo...

Hi All,we are planning to setup OAM for monitoring performance of our VPLS service interface? By checked Cisco document, I couldn't find related document  that can confirm Y.1731 support multi-point to mulit-point interface by full mesh topology in o...

What is the number of full rate (128pps) PTP client slaves supported on ASR9k platform configured with RSP 440 and working as boundary clock? Platform has MOD80-SE and MPA-4x10G LCs.Thank you,Danijel

I´m installing a XFP-10G-MM-SR on a CRS-FP140 card. However, according to the XFP Compatibility Matrix on CRS, this Version and type of module is not supported. The problem is that we don´t know the version of the XFP when we are in the purchasing pr...

Hi XR folks, I enabled this feature on XR 4.3.2 as following configuration,logging archive device harddisk severity notifications file-size 5 frequency daily archive-size 100 archive-length 4 The issue is,There have no Archiving logging file be gener...

Hi SP Folk,BackgroundI need to provide L3 termination for CE device.CE device on the production having no vlan tagging capability.Scenario. (See also attachment , diagram)There are ASR9K and ASR903 connected together,running VPLS as followingASR9K co...

HiI have two ASR9k with ISM modules running the CGN NAT serviceI have configured two /21 pools on each box , which means 4096 IP address for each box , when I check the statisticsRP/0/RSP0/CPU0:CGN-3G-NAT1#show cgn nat44 nat1 statisticsStatistics sum...

In a month the second case all are disconnected Rrroyesessii and new aren't connected not to reboot a router yet.Messages RP/0/RSP0/CPU0:Feb 12 20:17:00.396 : pppoe_ma[378]: Bundle-Ether100.10: I dst ffff.ffff.ffff src bcee.7bed.90a0: len 46 0x110900...

Hello, This past summer we migrated from a 10K to a 9K.  On the 10k we were using IP unnumbered sub-interfaces pointing to loopback and using helper addresses pointing to external DHCP.  During initial configuration of the 9k we were unable to use DH...

Hello,How can you check the uptime of a card on an ASR1006?We had ESP20 that was constantly crashing, yet the timers didn't change.if you do a "show platform" It only shows the time when the card was installed in the chassisChassis type: ASR1006     ...