XR OS and Platforms

Hello guys! I'm trying to apply autoroute annouce command to PCE initiated LSP by using Configuration group command but without result. It doesn't work. Autoroute disabled for pce initiated LSPs. May be I do smth wrong. Please help. Or advice anothe...

Hello! Only question, how could i do to change the % trigger for the following alarm %PLATFORM-PLU-4-TBM_INCONSISTENT? Is it possible? The alarm is triggered when the it reaches 95% occupancy on any channel PLU memory. I want to lower the limit to 80...

Hi team, I am NCE III in America Mobile, in Guatemala, and in this moment I have a project whit the installation of 1 license in NCS6008 for 2 SFP CPAK 100G.   PID: S-NC6-PAYG-200-M=  NCS 6000 2x100GE Multiservice PAYG Upgrade License    Quantity: 1...

Is there any functional difference between BRAS and BNG

We have Multiple Hop EBGP configured on our network with no BGP BFD or BGP dampening(Third party vendor <> ASR 9k ver 5.3.3). An engineer removed the static route by mistake. Ebgp session went down only after 1min and 22 sec. It also black holed traf...

Dear all, Can anyone Help me.I am trying to configure ASR9K with  XR to periodically archive the configuration in folder by an ftp server. The objetive is to periodically archive the running configuration to a folder by an tftp server. The period to ...

Hi all,  We're trying to cap bandwidth on an Ethernet Bundle subinterface to 50mbps, but regardless of what we do, is just doesn't cap it at exactly 50 Mbps. What we did notice though, is that a ‘normal’ file download is limited to 50Mbps but certain...

Hi, In order to experiment with the NETCONF and OpenConfig capabilities of the OS I wanted to download the virtual image from here https://developer.cisco.com/site/ios-xr/. However when I click on the Download button I get redirected to this page: ...

We recently purchased a few ASR 920's and found that the software rev we are running does not support the use of errdisable commands. Previously we had used 'no errdisable detect cause link-flap' and 'errdisable recovery cause link-flap', but these c...

We are running Multi HOP BGP in our network between Cisco NCS6k and Juniper. we are running 5.2.4 code in NCS6k and looks like it does not support BFD for Multiple HOP BGP. Multi HOP BGP is used to peer using the loopbacks and static route is used to...

On CCO there is the 9922, 9912, 9904 but not the 9910 code ??????????