Dears.I need a free netflow server, my router is ASR1006 and the traffic is 600 Mbps, the netflow server should support NAT because when I was setting ip nat translation syslog on my router, his CPU was 80%.thanks
Hey guys,
I've got an ASR9K that's connected to a Layer 2 circuit (VZ EPL/EVPL). I want to be able to run BGP as well as extend a few VLANs across the same Layer 2 link to the far-end. Is this possible over the same L2 link?
Any direction with conf...
Hi Experts,
I have a question regarding to mac address learning on ASR9K.
Per the log below, I am curious that why the mac address is learned from different location? one is from LC, and another is from RSP.
RP/0/RSP1/CPU0:LAR712#sho l2vpn forward...
I installed SP9 oder SP8 and now both are active:
Node 0/RSP0/CPU0 [RP] [SDR: Owner] Boot Device: disk0: Boot Image: /disk0/asr9k-os-mbi-5.1.3.sp9-1.0.0/0x100305/mbiasr9k-rsp3.vm Active Packages: disk0:asr9k-k9sec-px-5.1.3 disk0:asr9k-bng-px-5.1.3...
Dear Experts,
will RSP440-LT (with 8GB RAM) card support to from ASR-9006 nV Cluster/edge systems ?
since that card is brand new and not mentioned in any document related to nV.
and last,
with latest version of IOS-XR,
is VSM be supported in nV Clu...
Hi,
I tried mounting IOS XRV v 6.0 and v 5.3.2 on to ODL using restconf, but its unsuccessful
Trace logs are mentioned below:
IOS XRv version: 6.0
[06/24/16 11:17:07.685 UTC 26f1 1147094] ERR: nc_sm_process_rpc_get_schema_message:3844 Failed ...
This session will provide an opportunity to learn and ask questions about Cisco IOS XR Software architecture which is modular and fully distributed network operating system used by most of the leading service providers in the industry. IOS XR is w...
Hi all ,Strange lines apperas in log on Cisco ASR 1004 RP2 ESP20 Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-ADVIPSERVICESK9-M), Version 15.2(2)S, RELEASE SOFTWARE (fc1)asr1000rp2-advipservicesk9.03.06.00.S.152-2.S.binUsing him to terminat...
Has anyone been successful at getting a L2VPN established between these two chassis? It appears the ALU is good (LSP/SDP is up/up) but the L2VPN (VPLS instance) will not establish. I'm using RSVP signalling and the LSP(ALU) is up and the Tunnel-TE (C...
Ok we just got our ASR9k1 and we are trying to get to the most stable version but i dont know if its just me but its been frustrating so far.
First can't decide between which image to use, tried looking at the features comparer and basically still ...
Hi,
If I have CRS 72 LCCs and 8 FCCs, one FCC chassis is a fabric plane, but for two different LCC, their fabric plane , for example, fabric plane 0, connected to 3 oim card, such as LCC0 fabric plane 0 3 oim connect to FCC0 slot 0,1,2 (horizi...
Hello all
We have a setup of ASR9K offering PPPoE termination services. For the bulk of our subscribers we offer public IPv4 but due to the lack of available address space we also start giving private IPs / CGN (and placing corresponding subscribers ...
We ran into this tonight turning up some ASR9001 boxes. Looking for more information.
Log message:
RP/0/RSP0/CPU0:2016 Jun 13 23:26:16.860 UTC: mrib[1145]: %ROUTING-MRIB-3-TLC_ERR : No TLC entry (lcl/add) while processing fwd upd, lcl_tid 0xe000000...
