XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hello,We are going to do an upgrade on some asr9k´s from 4.0.1 to 4.2.3. Current IOS-XR software is installed in disk0, so my question is if it´s possible to install the new software packages (pies and SMUs) in disk1 and then to select this one to bo...

Hello everybody,I can't find the command "verify /md5 disk1:c7200-js-mz". I have found something simular, but I am not sure how to use it:RP/0/RSP0/CPU0:R01#admin install verify packages location ?                                      0/0/CPU0     Fu...

kozorezdi by Level 1
  • 8585 Views
  • 2 replies
  • 0 Helpful votes

HiWe are implementing DDoS solution in our network and the netflow protocol is lunch on core routers - the CRS-3I've got the folloing monitor-map:flow monitor-map arbor-ddos-mpls record mpls ipv4-fields exporter arbor-ddos cache timeout active 30 cac...

Hiactually we have two ASR 9000 with follow info:RP/0/RSP1/CPU0:ED_MEX_1#show licenseTue Oct 22 09:10:06.835 UTCFeatureID: A9K-AIP-LIC-B (Slot based, Permanent)Total licenses 2Available for use 2Allocated to location 0Active 0Store name PermanentStor...

With Vinay Kumar, Sudhir Kumar and Raj Pathak   Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about Cisco Carrier Routing System (CRS) single-chassis and multichassis router hard...

hiI wanted to get an answer to a question related to using the apply command inside route-policiesI have an rpl that calls two sub policies sequentially.if inside the first sub policy I set the prefix to have a drop terminating statement, does this j...

Hi,I am really struggling with MPP on ASR 9001.I am sure this was working previously but anyway I have an issue where I believe I had MPP configured and working to block ssh connections, I have since brought up BGP with a transit provider and now can...

Hi actually we are operating two ASR9000 on High availability on a network of MPLS, when ask the routing table for a expecific VRF have not trouble whit obtein it but when ask the general routing table the devices send the follow information:RP/0/RSP...