HiCurrently I have 4 slots occupied by the following cards on ASR9000:Slot 0 – A9K-8T-L Slot 1 – A9K-8T-L Slot 2 - A9K-2T20GE-L Slot 3 – A9K-2T20GE-L have VRFs configured on different ports within each card, the installation process was carried ...
Hello,We are going to do an upgrade on some asr9k´s from 4.0.1 to 4.2.3. Current IOS-XR software is installed in disk0, so my question is if it´s possible to install the new software packages (pies and SMUs) in disk1 and then to select this one to bo...
Hello everybody,I can't find the command "verify /md5 disk1:c7200-js-mz". I have found something simular, but I am not sure how to use it:RP/0/RSP0/CPU0:R01#admin install verify packages location ? 0/0/CPU0 Fu...
Dears,We have recently aquired a large network with ASR9K as Internet Gateways and non-Cisco devices in the MPLS Core.We would liike to know which is the best recommended solution to use Private MP-BGP AS in the MPLS Core or extend the IGW Public AS,...
hi friends,I have a particular requirement in which i am recieving PPPoE Subscribers on ASR 9010 running 4.2. I am recieving Subscribers Sessions in three formants1) username@abc.com2) username@xyx.com3) username1Is it possible that i let usernam...
HiWe are implementing DDoS solution in our network and the netflow protocol is lunch on core routers - the CRS-3I've got the folloing monitor-map:flow monitor-map arbor-ddos-mpls record mpls ipv4-fields exporter arbor-ddos cache timeout active 30 cac...
Hiactually we have two ASR 9000 with follow info:RP/0/RSP1/CPU0:ED_MEX_1#show licenseTue Oct 22 09:10:06.835 UTCFeatureID: A9K-AIP-LIC-B (Slot based, Permanent)Total licenses 2Available for use 2Allocated to location 0Active 0Store name PermanentStor...
Hello cisco team,We faced with an issue on XR 4.2.1.After we had removed access-group from interface: interface Bundle-Ether4.89service-policy output INET89ipv4 mtu 1500ipv4 point-to-pointipv4 address ipv4 verify unicast source rea...
Dear CSC (and hopefully Xander):What is the proper way of upgrading an asr9k cluster?Do i have to break the cluster and upgrade both 9ks separately? then rebuild the cluster?Or you just treat the cluster as one box and when you upgrade one of them, b...
With Vinay Kumar, Sudhir Kumar and Raj Pathak Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about Cisco Carrier Routing System (CRS) single-chassis and multichassis router hard...
hiI wanted to get an answer to a question related to using the apply command inside route-policiesI have an rpl that calls two sub policies sequentially.if inside the first sub policy I set the prefix to have a drop terminating statement, does this j...
Hi,I am really struggling with MPP on ASR 9001.I am sure this was working previously but anyway I have an issue where I believe I had MPP configured and working to block ssh connections, I have since brought up BGP with a transit provider and now can...