I am currently trying get DHCP to work on the 9906. Currently I am using it as a Relay Agent.I am trying to attach a L3 ip address scheme to a loopback interface so i can share those pools across multiple service tags. (561,562,563,ect Vlans) When ...
Hello,
could someone explain me the benefits of PWHE over Routed VPLS configuration on IOS XR platform?
Both configurations provide the termination of access pseudowires (PWs) into a Layer 3 (VRF or global) domain.
So I would like to know if the ke...
Hello There,We have 2 x GigabitEthernet part of Bundle-Ethernet. While trying to apply 1500mb service policy, Bundle-Ethernet changes to "Down" state. If I try putting 300mb service policy, Bundle-Ethernet changes to "up" again.Is there any limitatio...
Hello, I am trying to configure flowspec on cisco XRv9k on CML2. While configuring flowspec I see the following error.flowspecaddress-family ipv4service-policy type pbr p1!!% 'FlowSpec' detected the 'warning' condition 'FS MGR': Operation not support...
In ASR9K, I have a bundle-ether20 that has two physical ports as members TenG1/1 & TenG1/2The bundle-ether20 has two subinterfaces bundle-ether20.1 & bundle-ether20.2I want to apply ACL on this connectionQ1) Shall this ACL be applied on the physical...
Hi all,We are running ASR 9000 in our core and edge. all routers are running isis, bgp and mpls. we have multiple redundant links and have configured isis for UCMP. Since some of the redundant links have small difference in delay, we are experiencing...
We've recently added A9K-AIP-LIC-B. Slot based license. We have two.
It shows up:FeatureID: A9K-AIP-LIC-B (Slot based, Permanent) Total licenses 2Available for use 2Allocated to location 0Active 0Store name PermanentStore index 1Pool: OwnerTotal ...
We are dealing with a migration from IOS XR ASR9k 10G port to 100G port and facing the issue with INPUT errors, no CRC. We did some loopback test from the patch panel to our provider equipment, from the fiber back to our provider equipment, and no i...
Hello Cisco community.I have been doing some research on running BFD with BFD Dampening and IP Event Dampening together as a method to ensure that BFD is detecting these layer 3 type failures and correctly notifying upper layer protocols of failures ...
HI ExpertsI found Cisco ASR9K don't support MSDP.I found that Cisco A9K does not support MSDP. Does that mean that A9K does not support inter-domain multicast? Is there any other way or configuration to replace it (inter-domain multicast)?FeatureIPv4...
Hi EveryoneIs BGP Flow Spec Supported on NCS540 ? i know that it is supported on ios XR and ASR9K and NCS5500 but i don't know if it is supported on NCS540 or not.Can you please help me?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: