XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hello All, The 'show inventory' of an ASR9010 shows the details of some XFPs that was removed:RP/0/RSP0/CPU0:ASR9k#sh inventory (…)NAME: "module 0/0/CPU0", DESCR: "4-Port 10GE Line Card, Requires XFPs"PID: A9K-4T-B          , VID: V05, SN: 1234567890...

Hello All,Traffic tagged with outer vlan 3050 and inner vlan 350 isn't matching the following L3 interface configuration:interface GigabitEthernet0/4/0/28.3050 vrf ABC ipv4 address 20.0.0.11 255.255.255.0 encapsulation dot1q 3050Even with no second t...

dfranjoso by Level 1
  • 992 Views
  • 2 replies
  • 0 Helpful votes

Hi,The ACE primary of platform XPTO (6509 + ACE20) failed to give service and failed to see the secondary and the opposite too, getting the two active.10134123245 syslog 02/09/2012 14:05:42 09/02/2012 14:05:42 1 Feb 9 Feb 2012 13:42:55 XPTO:% ACE-2-7...

Hello All,Are there any best practices guidelines for the configuration of a "system-ip-address" on a IGMP SNOOPING profile ?igmp snooping profile TESTES_SNOOPINGsystem-ip-address 1.1.1.1internal-querier!For instance, using a different "system-ip-add...

dfranjoso by Level 1
  • 1218 Views
  • 1 replies
  • 0 Helpful votes

Hello All,After replacing some power-suplies we noticed the two of them show a slight diference in "Power Draw" and "Current". Everything else looks OK and I would say that there is no problem with the power-supplies. However just to be sure, please ...

HiRecently, i encounter an problem on using Distribute-list with ACL in IOS-XR OSPFv2.I am trying to filter a single route 10.10.0.0/16 with the following ACL, 10 deny ipv4 10.10.0.0/16 any 20 permit ipv4 any anywhich deny 10.10.0.0/16 and longer pre...

CC11 by Level 1
  • 5088 Views
  • 7 replies
  • 0 Helpful votes