XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Take

 

Forum Posts

Hello,I have a question about the following show command:RP/0/RSP0/CPU0:ASR9010(admin)#sh environment temperatures Fri Feb 17 08:20:50.905 SCHILER/S/I   Modules Sensor                  (deg C)0/0/*        host    Inlet0                  33.2        h...

Hi Expert,I tried to configure policing in class-default and applied to L2 interface but after commit i got the error % 'qos_ea' detected the 'fatal' condition 'Unsupported police action for L2 interface'. I try to research but not found any restrict...

Rojer-bkk by Level 1
  • 1118 Views
  • 1 replies
  • 0 Helpful votes

I have inserted a SIP-800 card into my CRS-8.   I inserted the SPA into the SIP.   I cannot find how I configure the SIP or the SPA.  I have spent the day reading the manual but no where do I see the commands to activate or get the SIP up and running...

Hi Everyone,This is my first post in this CISCO community, so again HELLO.Regarding the SNMP traps in ASR 9010 (I use IOS-XR:4.1.2), which trap is used to get notifications when the transceiver power is low or below the threshold, also is there a doc...

saikchak1 by Level 1
  • 5613 Views
  • 5 replies
  • 0 Helpful votes

Hello dear IOSXR experts,I have the need to limit user access to a ASR9K box like this:Service_Operator -> access to configure/monitor L3VPN, L2VPN (VLL&VPLS), Edge QoS (edge interfaces), MVPN, etc;Core_Operator -> access to configure/monitor IGP,BGP...

dfranjoso by Level 1
  • 1535 Views
  • 2 replies
  • 0 Helpful votes

Hello,we are using the following configuration to a QinQ link in the subinterface to our users:interface GigabitEthernet0/0/0/3.900 l2transport description To CUSTOMER - PSEUDOWIRE A encapsulation default l2protocol cpsv tunnel!interface TenGigE0/1/0...