XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Take

 

Forum Posts

Hello All,Traffic tagged with outer vlan 3050 and inner vlan 350 isn't matching the following L3 interface configuration:interface GigabitEthernet0/4/0/28.3050 vrf ABC ipv4 address 20.0.0.11 255.255.255.0 encapsulation dot1q 3050Even with no second t...

dfranjoso by Level 1
  • 1245 Views
  • 2 replies
  • 0 Helpful votes

Hi,The ACE primary of platform XPTO (6509 + ACE20) failed to give service and failed to see the secondary and the opposite too, getting the two active.10134123245 syslog 02/09/2012 14:05:42 09/02/2012 14:05:42 1 Feb 9 Feb 2012 13:42:55 XPTO:% ACE-2-7...

Hello All,Are there any best practices guidelines for the configuration of a "system-ip-address" on a IGMP SNOOPING profile ?igmp snooping profile TESTES_SNOOPINGsystem-ip-address 1.1.1.1internal-querier!For instance, using a different "system-ip-add...

dfranjoso by Level 1
  • 1415 Views
  • 1 replies
  • 0 Helpful votes

Hello All,After replacing some power-suplies we noticed the two of them show a slight diference in "Power Draw" and "Current". Everything else looks OK and I would say that there is no problem with the power-supplies. However just to be sure, please ...

HiRecently, i encounter an problem on using Distribute-list with ACL in IOS-XR OSPFv2.I am trying to filter a single route 10.10.0.0/16 with the following ACL, 10 deny ipv4 10.10.0.0/16 any 20 permit ipv4 any anywhich deny 10.10.0.0/16 and longer pre...

CC11 by Level 1
  • 5984 Views
  • 7 replies
  • 0 Helpful votes

Hello A9K Olympus inhabitants,I have some questions to you regarding the way the A9K deals with dot1q tag on the egress EFP:First scenario:The frame arrives the ingress EFP (port-mode, with no encap, only l2transport config) with a dotq1 tag of 100;T...

dfranjoso by Level 1
  • 1484 Views
  • 2 replies
  • 0 Helpful votes

Resolved! trust dscp

dear all,What is the default behaviour on CRS nodes when it comes to incoming packets,  is packets marking trusted or maked down ?I tested trusting via policy map, but option was not available to trust. Is there a similar command to IOS to explicitly...

I have a few Q's regarding on IOS XR on the 12000I understand the boot time of XR on 12000 can take a while compared to IOS. How long on average does it take ? How long does it take to apply SMU ? Do people prefer XR over IOS and what are the Pro's V...

mdwheadon by Level 1
  • 1998 Views
  • 3 replies
  • 0 Helpful votes
Top Solution Authors