Hello,Due to a missconfiguration of the TACACS+ service on my ASR9k, now i'm locked out of it, the console port can't issue any commands, it always shows this: "Command authorization failed - 'AAA API' detected the 'fatal' condition 'No method could ...
Does anyone know if MC-lag is supported in latest IOS XR release for NCS 5500 series. Or has it been replaced with EVPN Multi-homing?
hi everyoneI need to check if the new 2 A9K-8X100GE-L-SE line cards we bought are goodI inserted the first line card, and it get stuck on IN-RESET state.and the second is stuck in UNPOWERED statewhat could be wrong? it should be noted that the lines ...
Dear colleagues, I have new question about Subscriber redundancy group. ASR 9006, RSP440-SE, iOS-XR Version 6.4.2, 32-bit. What is the maximum number of entries in state-control-route directive I can use ? I read this topic: "A maximum of 30 state co...
I plugged in the A9K-MOD80-SE and the A9K-MOD80-SE PLATFORM-SHELFMGR_HAL-3-CBC_OFFLINE log is output. Is it a bad card? shelfmgr[400]: %PLATFORM-SHELFMGR_HAL-3-CBC_OFFLINE : 0/5/CPU0 CBC processor is offline It does not appear to be online.
Hi, Does XR support RR operation when you want to send multiple equal paths (multiple best routes) to route-reflector-clients (bgp additional-paths)? I've worked with this on a lab where RRs are XE and support the "neighbor advertise additional-path...
Hi, all. I need an information what I said in the topic. I already checked "Overview and Reference Guide", "Installation Guide", and "Datasheet", but couldn't get any information about RPM range or temperature range. They are saying just it depends o...
Hi,I try to implement SRv6 Service Chaining.I have a VRF on a PE routeur with two host on this PE in this VRF.On an other PE (call PE-FW) i have the same VRF with a FW connected on it.I want traffic from host A to go to the PE-FW and go to the FW and...
Hi allI was trying to password recovery my ASR 9006. in process of struggling to get into ROMMON which I wasn't able, the IOS XR crashed. When I trying to boot from USB (FAT32 filesystem) following message is shown. It worth mentioning that I had tri...
Hi,I have an IOS-XR edge router with 2 equal cost static routes with an AD of 1.But one network Is only accessible via ISP2 and and all traffic seems to be going down the static route for ISP1. Am I missing anything.Please see photo and outputs attac...
I have four NCS55A2 in lab and have been relying on them a lot lately. I noticed that two of them, the console ports are not working. I traveled to the office today and swapped console cables around, and the console cables and that device appear to b...
Hello everyone,I have an NCS55A2 router that I mistakenly rebooted using the 'reload' command, but the router only has a single supervisor card. After issuing the command, I encountered several issues regaining console access to the device, and now I...
Hello everyone, Thanks in advance.
We have faced load-balance issue on NCS routers. So one of the routers was reloaded and after reload bundle load balance mechanizm runs not correctly. the bundle interface is L2 and there are many subinterfaces.first interface's traffic is 100%, seco...
