cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
798
Views
0
Helpful
6
Replies
Participant

ceRedunEventSwitchover trigger

Hi Guys,

 

any of you know how to triggre the ceRedunEventSwitchover traps.

i'm not able to receive this trap using redundancy switchover command

 

Regrads 

6 REPLIES 6
Participant

Re: ceRedunEventSwitchover trigger

i forgot...it is ASR 9912
Cisco Employee

Re: ceRedunEventSwitchover trigger

which release?

Participant

Re: ceRedunEventSwitchover trigger

6.1.4
Highlighted
Cisco Employee

Re: ceRedunEventSwitchover trigger

And you have the following configured in SNMP?


snmp-server traps entity-state switchover

snmp-server traps entity-redundancy all

snmp-server traps entity-redundancy status

snap-server traps entity-redundancy switchover


Eddie.
Participant

Re: ceRedunEventSwitchover trigger

Hi Eddie,

 

first of all thank you for your kindly reply.

For sure i enabled all the traps you wrote down.

I think, but not sure, manual switchover does not trigger this trap

Regards

 

Beginner

Re: ceRedunEventSwitchover trigger

A manual RSP/RP FO with the "redundancy switchover" command should trigger this. Do you have a route to your NMS at all times and its available right after the FO happens on the new active RP/RSP?

If so you probably want to have this looked at further and with these commands:

debug snmp general

debug snmp trap

debug snmp mis rfmib

Clear log

redundancy switchover

Log back in after the RP FO

sh snmp traps

sh snmp traps details

sh snmp trace traps

sh logging

Regards
Eddie.
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards