cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1331
Views
10
Helpful
2
Replies

Cisco ASR 9006 - Upgrade to 6.2.3 from 5.3.3

davidwilko
Beginner
Beginner

Hi,

 

We have a couple of Cisco ASR 9006's which we are looking at upgrading to 6.2.3, Can we directly upgrade from 5.3.3 (32bit) to 6.2.3 (32bit)?

 

Looking at the upgrade documentation it suggests their might be a need to install bridge SMUs before upgrading. I see a bridge SMU listed under 6.2.2 but not for 6.2.3, so I'm wondering if 6.2.3 doesn't need one or if I have to go via another version before getting to 6.2.3?

 

Thanks

 

David

1 Accepted Solution

Accepted Solutions

smilstea
Cisco Employee
Cisco Employee

There doesn't appear to be any bridge SMU needed. You can upgrade directly so long as you aren't using the RSP-4G/8G or any trident based LCs (-E -B -L, -SE and -TR are fine).

 

Sam

View solution in original post

2 Replies 2

smilstea
Cisco Employee
Cisco Employee

There doesn't appear to be any bridge SMU needed. You can upgrade directly so long as you aren't using the RSP-4G/8G or any trident based LCs (-E -B -L, -SE and -TR are fine).

 

Sam

Hi Sam,

Thanks for confirming and no trident line cards.

Regards

David
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: