12-09-2011 12:27 AM
Hello,
i just moved services from GSR 12404 to CRS1/8 and there is no possibility do add service-policy to L3 subinterface.
RP/0/RP0/CPU0:XXX#conf t
Fri Dec 9 09:25:55.690 CET
RP/0/RP0/CPU0:XXX(config)#interface tenGigE 0/0/0/0.900
RP/0/RP0/CPU0:XXX(config-subif)#service-policy input 300mbps
RP/0/RP0/CPU0:XXX(config-subif)#commit
Fri Dec 9 09:26:06.587 CET
% Failed to commit one or more configuration items during a pseudo-atomic operation. All changes made have been reverted. Please issue 'show configuration failed' from this session to view the errors
RP/0/RP0/CPU0:XXX(config-subif)#show configuration failed
Fri Dec 9 09:26:11.842 CET
!! SEMANTIC ERRORS: This configuration was rejected by
!! the system due to semantic errors. The individual
!! errors with each failed configuration command can be
!! found below.
interface TenGigE0/0/0/0.900
service-policy input 300mbps
!!% 'qos_ea' detected the 'fatal' condition 'QoS is not supported on sub-interfaces'
!
end
Any help ?
Solved! Go to Solution.
12-09-2011 12:47 AM
Hello Dragoljub,
Qos on vlan interfaces is not supported for FP140/FP40 LCs.
“MQC-based QoS configuration will be accepted only on the port level but not on the VLAN subinterface level.”
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.8.4/general/release/notes/reln_384.html
Regards,
/A
12-09-2011 12:47 AM
Hello Dragoljub,
Qos on vlan interfaces is not supported for FP140/FP40 LCs.
“MQC-based QoS configuration will be accepted only on the port level but not on the VLAN subinterface level.”
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.8.4/general/release/notes/reln_384.html
Regards,
/A
12-16-2011 02:55 AM
Actualy it is possible to match VLAN on physical interface and make something like this.
interface TenGigE0/0/0/0
service-policy input customers-qos
service-policy output customers-qos
interface TenGigE0/0/0/0.100
desc customerA
interface TenGigE0/0/0/0.101
desc customerB
class-map match-any vlan100
match vlan 100
end-class-map
!
class-map match-any vlan101
match vlan 101
end-class-map
policy-map customers-qos
class vlan100
police rate XXX mbps
conform-action transmit
exceed-action drop
!
!
class vlan101
police rate XXX mbps
conform-action transmit
exceed-action drop
!
!
This works perfect.
10-01-2014 08:48 AM
Hello,
I am trying to configure QoS in CRS with FP140. We have the release 4.2.1.
This link has an example but we are receiving the same error.
Do you know if this support is hardware based?
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide