02-11-2014 09:35 AM
Hello,
is there any way to know which brdige domain/P2P Xconnect is getting more utlizaiton or traffic.
since many BD are sharing the same physical interface there is a need to know which BD is getting more of link bandwidh.
Mohamed.
02-26-2014 09:15 AM
Hi Mohammed,
You can run mpls netflow on the core facing interface and based on the VC label you can figure out which pseudowire is getting lot of traffic.
other way to check would be "sh l2vpn bridge-domain bd-name xxx detail" and look at the
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
which will be cumbersome if you have lot of p2p in the network.
HTH,
Chander
03-01-2014 01:00 PM
Hi Hemachander,
Thanks for your respond, what we are looking for is "input rate" or "output rate" which is
also not available on XR, even sub-interfaces showing the rx and tx as "Unknow".
with ISP 10G links facing core, it's seem to be impossible to look into these value and found out the issue from XR side.
Again, thanks for your help.
Mohamed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide