In IOS XR access list. Which packets will be permitted ?
Refer to the command:
ipv4 access-list FILTER 10 permit tcp any 192.168.15.32 0.0.0.15 eq www 20 deny ipv4 any 192.168.15.32 0.0.0.15 30 permit ipv4 any any
The access list has been configured on the Gi0/0/0/0 interface in the inbound direction. Which packets that are sourced from 10.1.1.1 TCP port 1060, if they are routed to the Gi0/0/0/0 interface, will be permitted?
A. destination IP address: 192.168.15.49, destination TCP port: 80
B. destination IP address: 192.168.15.49, destination TCP port: 8080
C. destination IP address: 192.168.15.46, destination TCP port: 80
D. destination IP address: 192.168.15.41, destination TCP port: 8080
E. destination IP address: 192.168.15.36, destination TCP port: 80
F. destination IP address: 192.168.15.37, destination TCP port: 8080
What is it same in the IOS ? If it do follow to sequence. In sequence 30 permit source any destination any. I thought all choice are permitted. What do you think
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...