I have an ASR9K with BNG and a CPE that connects to PPPoE on my ASR9K.
I try RIPv2 between my CPE and my PE but impossible to send and receive my routes.
With debug, I have this: rip : ignored packet from 172.27.50.10 (could not find interface)
The problem is that in the RIP router configuration, I can not set PPPoE interface.
It works perfectly on an IOS-XE, but I could define a "network subnet".
I missed something, here is an example of my configuration :
! interface GigabitEthernet0/0/0/19.1799 service-policy type control subscriber PPP_PM pppoe enable bba-group DEDE encapsulation dot1q 1799 ! dynamic-template type ppp PPP ppp authentication chap pap accounting aaa list default type session ipv4 verify unicast source reachable-via rx ! !
pppoe bba-group DEDE service selection disable ! class-map type control subscriber match-any PPP match protocol ppp end-class-map ! ! policy-map type control subscriber PPP_PM event session-start match-first class type control subscriber PPP do-until-failure 1 activate dynamic-template PPP ! ! event session-activate match-first class type control subscriber PPP do-until-failure 10 authenticate aaa list default ! ! end-policy-map !
router rip vrf TEST
interface gigabitEthernet 0/0/0/19.1799
! neighbor 172.27.50.10 route-policy pass-all in ! !
My PPPoE Interface :
RP/0/RSP0/CPU0:ASR9K-TEST#sh subscriber session all Mon Nov 19 09:56:21.301 CET Codes: IN - Initialize, CN - Connecting, CD - Connected, AC - Activated, ID - Idle, DN - Disconnecting, ED - End
Type Interface State Subscriber IP Addr / Prefix LNS Address (Vrf) -------------------------------------------------------------------------------- PPPoE:PTA Gi0/0/0/19.1799.pppoe191 AC 172.27.50.10 (TEST)
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...