cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2037
Views
0
Helpful
10
Replies

ISIS database not installed in routing table

ar
Level 1
Level 1

I joined an XR into an existing ISIS IGP.

Just Plain level-2 ISIS configurations only.

I can see information in "show isis database"

but not installed in routing table.

Any comments?

10 Replies 10

Yigal Dekalo
Cisco Employee
Cisco Employee

Hi,

Can you post the isis config and the output of both routing table and isis database?

Here...

router isis 1
 is-type level-2-only
 net 49.0001.1920.1610.1002.00
 nsf ietf
 log adjacency changes
 lsp-gen-interval maximum-wait 20 initial-wait 5 secondary-wait 1
 address-family ipv4 unicast
  metric-style wide
 !
 interface Loopback0
  circuit-type level-2-only
  lsp-interval 65000
  address-family ipv4 unicast
  !
 !
 interface TenGigE0/0/0/0
  circuit-type level-2-only
  lsp-interval 65000
  address-family ipv4 unicast

#sho route isis
Fri May 13 18:46:13.053 UTC

% No matching routes found

IS-IS 1 (Level-2) Link State Database
LSPID                 LSP Seq Num  LSP Checksum  LSP Holdtime  ATT/P/OL
A.00-00  0x00000396   0xd448        25113           0/0/0
A.01-00  0x0000029e   0x1541        51751           0/0/0
B.00-00  0x000004e8   0xeace        14294           0/0/0
B.09-00  0x000002e2   0x5498        16427           0/0/0
03-N.00-00  0x0000170e   0x0aa7        600             0/0/0
04-N.00-00  0x0000174f   0x498a        720             0/0/0
04-N.01-00  0x00000a51   0x6d19        1102            0/0/0
04-N.02-00  0x00000b63   0x4491        1028            0/0/0
04-N.04-00  0x0000089a   0xd0ce        890             0/0/0
router1.00-00* 0x0000104f   0xb559        1175            0/0/0
router1.01-00  0x00001002   0x35a0        886             0/0/0
r.00-00  0x001196a2   0x04f1        65286           0/0/0
r.02-00  0x00000d98   0xa485        61209           0/0/0
r.04-00  0x0000025b   0xe15f        62854           0/0/0
R2.00-00  0x0001ecb6   0xaf51        57039           0/0/0
2.00-01  0x000013e9   0xef96        58081           0/0/0
2.01-00  0x000009c1   0x17bb        62990           0/0/0
2.02-00  0x000009d7   0xe3d7        62735           0/0/0
R2.03-00  0x000002df   0xc8fe        64475           0/0/0

any idea?

By the way, the adjacent router is a Nexus 7710 device.

Only ISIS LSPs coming from 7710 is not being installed in the ASR9K RiB.

I tested to enable ISIS with another adjacent router but this time another ASR9K and works fine.

Is there an issue with Nexus LSP propagation?

did you find solution to this, I have same scenario in reverses. I have ISIS configured between ASR9k and Nexus 9k and routes are not being installed in Nexus device but i can see those in ISIS database. 

Unable to continue troubleshooting due the project was stopped.

Not sure if there's compatibility issues between XR and NX-OS.

apparently it was a bug and nxos was upgraded to resolve this. 

can you share the bugID?

it was communicated as "internal" bug, so not pasted on cisco's website.  

what NX-OS version solved the issue?

7.0(3)I2(2d) solved it. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: