Hello guys,
I have installed a new IOS-XR 6.1.2 version and I have a problem with command "show hw-module ...", cli just doesn't allow to issue this command.
Back in 5.2.4, it was working without a problem (the same configuration) and from my lab test results it seems like there is some problem with privileges.
When I configure a user who belongs to a taskgroup with all tasks setup with READ, I am still not able to use the command.
The only working solution was to add the user into some other predefined group as well, e.g. Netadmin.
Maybe some other commands are impacted as well ...
Anyone knows why is this so?
Thank you a lot,
Michal.