SPA-1X10GE-WL-V2 not working

[TarcisioSeanet]

Hello.

I'm having problems with a SPA-1X10GE-WL-V2 on my Cisco ASR 1002x.

I currently have two SPA-1X10GE-L-V2 and a SPA-1X10GE-WL-V2 but the WL is not working.

I researched and found the command to force the LAN mode, because without, it wasn't linking with my Huawei S6720.

Once I got it to link with my switch, I put it on a Port-Channel, with the other. But the LACP haven't worked either.

I thought it was incompatibility with the other two modules, so for a test I made another Port-Channel with just that one port. It didn't worked either.

So finally i just decide to put some vlans on the port and tried use, but then again, it didn't worked.

My final thought is that this module is simply not working. Do I have some troubleshooting to do with it? Another test? Some debbuging command for verifiyng the health of the SPA module? 

Many thanks in advance.

[balaji.bandi]

Is this module recognised on the device ?

can you post show modules and check the on the device log , do you see any information ? what IOS XE code running ?

what SFPs have you tried ?

[TarcisioSeanet]

Yes, it does recognize the board, it is a different version than the others, newer. 

I didn't see anything on log. It just gets the interface UP then nothing happens. Just it doesn't work. No errors. 

The SFP is a Cisco branding one, model XFP-10GER-192IR+. It works on the other two boards, the SPA-1X10GE-L-V2.