Re: UNTESTED output for admin diagnostic start location 0/0/CPU0 test all-test
SRSP tests are only run on the standby RP/RSP, not LCs. Are you sure you're not looking at the output of "show diagnostic result" for the active RSP or RP? The command "diagnostic start location 0/0/CPU0 test all-test" produces no ouput when I try it (asr9k/xr 6.5.3).
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...