10-25-2012 01:22 AM
Hi
I have some questions about VRF configuration on IOS-XR 4.1.
I'm trying to configure BGP routing with vrf and I get the
following error when trying to commit my config:
===================================================
address-family ipv4 unicast
!!% 'BGP' detected the 'warning' condition 'The parent address family
has not been initialized'
===================================================
However, It is solved by configure "address-family vpnv4 unicast"
before committing the vrfs.
But, I'm not sure about that above configure are best practice or not.
Q1. Do you have a best practice configuration of BGP with VRF?
or
Q2. I have to use "address-family vpnv4 unicast" on IOS-XR ?
Please advice me.
Best regards,
Kim
Solved! Go to Solution.
11-07-2012 09:05 PM
Hi Kim ,
you must configure "address-family vpnv4 unicast" on BGP globally so you will be able to commit the configuration for the address-family.
You can refer the below link to understand how MPLS L3VPN's are configured on IOS-Xr.
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.5/mpls/configuration/guide/gc35v3.html#wp1026378
11-07-2012 09:05 PM
Hi Kim ,
you must configure "address-family vpnv4 unicast" on BGP globally so you will be able to commit the configuration for the address-family.
You can refer the below link to understand how MPLS L3VPN's are configured on IOS-Xr.
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.5/mpls/configuration/guide/gc35v3.html#wp1026378
11-11-2012 11:18 PM
Hi Kumar
Thank you for your support.
Best regards
Kim
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: