11-30-2016 04:39 AM
Dears,
concerning the VSM built-in 4 x 10G ports as per guide below they are not currently used, i just need to confirm this issue, and if any information on future use (VSM sync, etc. ??)
The four 10 Gigabit Ethernet SFP+ module ports and their associated LEDS on the VSM card are not supported in the current release.
Link: http://www.cisco.com/c/en/us/td/docs/routers/asr9000/hardware/vsm_line_card/installation/guide/vsmig/vsmig_install.html#58562
Regards
Sami
11-30-2016 06:07 AM
Hi Sami,
you are correct, the ports are not useable. We currently don't have any use-case for them in the roadmap.
Kind regards,
N.
11-30-2016 06:38 AM
Hi Nicolas,
thanks for the confirmation.
Regards
Sami
05-30-2017 03:38 AM
Hi Nicolas,
I have going through your following post:
https://supportforums.cisco.com/document/12885281/installation-steps-arbor-tms-asr9000vsm
may you please share with me a sample bgp configuration after finishing setup the installation as above?
Also is it necessary to use bgp flow spec?
thanks,
Haitham Jneid
06-01-2017 02:24 PM
Haitham,
Besides the TMS software on the ASR9K VSM card, you will also need to run the Arbor Peakflow SP on a UCS VM for this solution to work.
There is no specific configuration required for BGP, just a regular iBGP session between the ASR9K and SP or TMS.
The Arbor user guide has a lot of information on the setup of the SP and BGP.
Thanks
Vincent
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide