Where to get the ID for ISSU upgrade

[news2010a]

Hello folks, I have installed the PIEs for an upgrade via ISSU in the ASR9K.

Question:

I examine the content below from 'show install log' but I don't see the "ID" info. Please let me know where I can get the ID info?

#install activate id <> issu parallel-reload prompt-level none

RP/0/RSP0/CPU0:ASR9K-1#show install log
Fri Sep 18 22:08:32.300 UTC

Install operation 4 started by user 'admin' via CLI at 21:58:57 UTC Fri Sep 18
2015.
    (admin) install add /disk0:asr9k-mini-px.pie-5.1.3
    /disk0:asr9k-fpd-px.pie-5.1.3 /disk0:asr9k-mgbl-px.pie-5.1.3
    /disk0:asr9k-k9sec-px.pie-5.1.3
    Install operation 4 completed successfully at 22:00:01 UTC Fri Sep 18 2015.

--------------------------------------------------------------------------------

4 entries shown
RP/0/RSP0/CPU0:ASR9K-1#

[news2010a]

In the example below, I understand that is the number "operation 4".

[smilstea]

Correct, however as I communicated in the other thread ISSU is not supported for every version of code.

No upgrade to 5.1.3 supports this, please reference http://www.cisco.com/web/Cisco_IOS_XR_Software/pdf/ASR9K_ISSU_Overview.pdf.

Thanks,

Sam